Product Description

The S7720C-2CF2-PA Kollmorgen digital servo amplifier encompasses a PosI/O-Monitor expansion card. This servo amplifier must undergo a re-forming of its capacitors in its DC bus link circuit when it has been in storage for over a year. The product poses a risk of serious injury because of electrical shock if its live points are accessed. This device can be stacked one on top of the other up to a maximum height of three cartons. The unit can be set up very easily using the DRIVEGUI setup software. Its electrical installation must be done in compliance with the regulations for safety at work and after switching off the mains supply.

This amplifier is meant to be installed only in electrical machines and/or plants. This product is likely to restart automatically when the AENA parameter has been set to 1. This device should be adapted to the requirements of the machine in which it is installed by a setting on the PC. The unit comes with a CD-ROM that contains information on how to set up its expansion cards. Its 2CAN module is associated with its X6 connector.

This servo amplifier can be linked with 15 other amplifiers to be controlled by a single master. The product can be connected to a third-party stepper motor controller. This device has additional analog inputs and outputs that can be assigned pre-programmed signals. The unit depicts an AGND reference ground and an output voltage of +/-10 V for its analog outputs. Its inputs on the X30 connector can be connected to only tested outputs from a safety control system.