Product Description

The Kollmorgen AKM23F-CKM22-00 synchronous servomotor transmits power using its cylindrical shaft end. This motor has permanent magnets made of rare earth materials in its rotor. The product is accompanied by a nameplate stuck on its housing using an adhesive. This device encompasses ball bearings that must be checked for grinding noise. The unit depicts a maximum stacking height of 10. Its housing should be cleaned using isopropanol if it is dirty. This motor has a 24 V holding brake. This device comes with two Moles connectors fitted on 0.5m shielded leads. The unit has no customization. It uses the SERVOSTAR servo amplifier to control and monitor the holding brake. This motor needs an additional contact to be incorporated in the braking circuit in the normally open state for the safe operation of the holding brake. The product has a shaft that is balanced with a short or a half key. This device has a torque constant of 0.27 Nm/Arms with a tolerance of +/-10%. The unit operation should be terminated as soon as grinding noises are heard. This servomotor may have live power and control leads even when the output shaft is not rotating. The product related mounting plate and motor casing must be earthed as mentioned in the instructions manual of the servo amplifier. This device is meant to be in the de-energized state during its assembly and wiring. The unit can be wired only by staff qualified in electrical engineering. It is likely to get destroyed if the servo amplifier is set with the incorrect number of motor poles. This motor installation should be done in a site free of conductive and aggressive material.