Product Description

The Kollmorgen AKM23D-EFCN2-00 synchronous servomotor has a D type winding. This motor has a nameplate stuck using an adhesive on its housing. The product is delivered without a holding brake. This device features 95% relative humidity at rated conditions without condensation during operation. The unit offers high dynamics because of the rare earth materials used in the construction of its permanent magnets. Its axial force must never exceed the maximum permitted radial force. This motor has an IP 65 protection class. The product is designed such that it transmits power through its cylindrical shaft end using a locking thread but without the fitted key. This device must incorporate shielding at both ends for its brake control leads if these are included in the motor power cable. The unit and the servo amplifier have to be properly grounded during the setup. Its rated technical data is likely to get reduced because of the comcoder. This motor related power and control cables may produce electromagnetic interference if they are placed very close to each other. The product has to be assembled or wired only after the corresponding switch cabinet is turned off. This device is meant to be wired according to the wiring diagram given in the installation and setup instructions for the servo amplifier. The unit must not be overstressed when it is fixed in place during the assembly phase. Its cables are meant to be selected as per EN 60204 specifications and a motor choke is needed when the motor cable length is more than 25 m. The servomotor should have unhindered ventilation surrounding it.