Product Description

The AKM22E-ANSNR-02 synchronous servomotor produced by Kollmorgen is supposed to always be used with the manufacturer's SERVOSTAR servo amplifier. This product has a smooth shaft and no holding brake. The device is associated with a rotor length of 2. This unit uses special connectors for its connection. Its insulation clearances are not to be altered when it is being handled and/or transported. This product related couplings must be tightened with the help of the locking thread. This device related servo amplifier must be set with the correct number of resolver and motor poles to avoid motor damage. The servomotor operation should not result in an axial load on the shaft as far as possible. This unit has a shortened lifespan if the radial and axial loads on its shaft are above the permissible limits. Its earthing connection must be established using an electrical connection with a large surface area to suppress HF interference. The motor wiring is to be done by following the wiring diagram given in the setup and installation instructions of the associated servo amplifier. This product must be matched with the servo amplifier by comparing the rated voltage and current. The device needs a shielding connection to be established for the EMC connectors at both ends. This unit depicts 0.85 Nm rated torque. It has a weight of 1.1 kg. The motor length is based on the inbuilt feedback device. This product is characterized by a power derating of 6% for a site installation altitude of 1,000 m to 2,000 m over sea level. The device is not recommended for applications outside the ambient operating temperature range.