Product Description

The AKD-P01206-NBCN-0000 Kollmorgen servo drive is one of the multiple AKD series of Ethernet servo drives. This servo drive can be set up and programmed using the graphical user interface of the manufacturer’s WorkBench software. The product renders fast performance and has a high degree of flexibility and versatility. This device is CE Certified and RoHS Compliant. The unit tends to cause personnel injury or damage to property if it is used inappropriately. It may restart automatically after power on based on the parameters that are set. This drive shows different codes on its display according to its status during operation. The product is disconnected from the WorkBench software at the time of its startup. This device has a static IP address of 192.168.0.nn where ‘nn’ can take any value from 01 to 99. The unit does not get enabled if the HW Enable signal is not wired. Its DHCP/IP setting is independent of the rotary switches. This drive tends to run roughly when the filters are set to too low values. The product associated firmware can be downloaded from the Overview screen of the WorkBench software. This device related MAC address is displayed as a 48-bit address and cannot be changed by the user. The drive baud rate is set to auto if the S1 rotary switch is set to 9 and the S2 rotary switch is set to 0. This unit depicts fast acquisition of data. It has a compact and robust design. The product can be mounted only in the upright position. It must be taken care to ensure ventilation below and above the drive inside the control cabinet to avoid the possibility of overheating. This product should undergo a commissioning before it is deployed for the desired application.