Product Description

The AKD-P00607-NBPN-0109 Ethernet servo drive from Kollmorgen is a position indexer. This product needs a commissioning action to be carried out before it is put to use. The device setup process is quite easy because of the intuitive graphical user interface of its WorkBench software. This unit is connected with the PROFINET network through its X11 RJ-45 connector with two inbuilt communication LEDs. Its X11 connector is connected to the associated Ethernet interface of the PROFINET Master either through a network switch or directly using standard Car. 5 Ethernet cables when there is no power supply to the drive. The drive has a 255.255.255.0 subnet mask. This product helps in commanding multiple motions, adding time delay and modifying the process variables associated with a Base drive. The device encompasses a power section featuring a regen circuit that distributes the generated power dynamically among multiple drives connected to the same DC bus link circuit. This unit makes use of the TCP/IP Ethernet service channel onboard for fast data acquisition. It has no compatibility with one-phase industrial power supply networks. This product has no provision for any option card. The device depicts a warning code on its LED display as ‘n’ followed by a three-digit flashing code. This unit tends to get disconnected from the WorkBench software if the software is not able to communicate with the drive. It is possible to include a port number of the user’s choice to the IP address of the drive at the end. The servo drive uses the S1 rotary switch to set the most significant bit of the IP address and the S2 rotary switch to set the least significant bit.