Product Description

The AKD-P00307-NBPN-E000 position indexer servo drive offered by Kollmorgen is an Ethernet-based drive. This drive should not be used with machines that fail to comply with appropriate national standards or directives. The product must be checked for visible damage before it is turned ON. This device encompasses electrostatically sensitive components that tend to get damaged because of incorrect handling. The unit can be stored for a period without restriction for a maximum duration of one year. It does not require maintenance when it is operated as specified by the manufacturer. This drive should not be opened for cleaning as this can nullify the warranty. The product can be disassembled only by people qualified in electrical engineering. This device's associated heat sink temperature must be checked to see that it is below 40 ?C before touching it after operation. The unit is connected to a PROFINET network through a RJ-45 X11 connector. It has a subnet mask of 255.255.255.0. This product is connected to a PC using an Ethernet cable. The device parameters can be modified with very little effort using the WorkBench software. This servo drive is assigned a logic power through its X1 connector. The unit is enabled using the setup wizard of the WorkBench GUI. Its fault messages are displayed as the letter F followed by a three-digit numeric code. The product tends to run roughly if the filters are assigned too low values. This device has a B1 button on the front panel that displays the IP address when it is pressed. The unit has an encoder emulation connector that can work like either an input or an output.