Product Description

The AKD-P00306-NBPH-0000 AKD servo drive offered by Kollmorgen operates inside a control cabinet with sufficient clearance above and below it for sufficient ventilation. This servo drive needs some basic tools to be kept handy for its installation. The product depicts a rated input power of 1.2 kVA for S1 operation. This device encompasses one push-button and two rotary switches to support its operation. The unit has an update rate of 1.5 MHz. It is necessary to ensure that there is no condensation at any time on the servo drive. This drive assembly should be done near its power supply on a grounded and conductive mounting plate. The product uses an L shaped grounding plate conforming to EU standards. The device features a shielding for its X2 motor connector. This unit permits the routing of power cable shields through shield clamps to an additional busbar. Its EMC filtering must be incorporated by the user if needed. The drive connection is meant to be done only with the manufacturer’s cables. This product related grounding, equipotential bonding and radiation-reducing shields must not be removed. The device associated electrical installation only after switching the mains supply off and securing against restart. This servo drive has no SD card slot. The unit is connected with a DC bus brake resistor for the power supply at its X3 connector with seven pins. It is connected to the motor and the optional external regen resistor using shielded cables. This product produces up to 900 V high electric voltage during operation. The unit should never be touched during operation. Its DC bus link voltage must be measured after disconnecting the power supply and its components can be handled only after this voltage is less than 50 V.