VLT101175B5056

Product Description

The VLT101175B5056 has 18, 19 and 20 mode digital inputs which are set in 5-00 Digital Input Mode and the 29 mode digital input is set in 5-03 digital input 29 mode.  The drive can also be programmed from a PC via RS485 com-port by installing the MCT-10 Set-up Software.

The recommended supply voltage for the line power supply (L1, L2, L3) are 200–240 V ±10%, 380–480 V ±10% and 525–600 V ±10% respectively. The drive has true power factor ≥ 0.9 nominal at rated load

Pay closer attention when installing the VLT101175B5056 to an IT line power. Danfoss recommends a maximum supply voltage 440 V (3 x 380–480 V units) when connected to line power. When operating in IT line power set par. 14-50 RFI filter to OFF on all units. The VLT101175B5056 has a circuit capable of delivering less than 100,000 RMS symmetrical Amperes with a maximum voltage of 240/480 V.

The motor output has the following features

• Output voltage 0–100% of supply voltage
• Output frequency 0–200 Hz (VVCplus), 0–400 Hz (u/f)
• Ramp times 0.05–3,600 sec.
• Switching on output Unlimited

While operating the drive the ambient temperature must be at least 41° F [5°C] lower than the maximum ambient temperature. To ensure safety decrease the output by 1% per 328 ft [100 m] altitude above 3,281 ft or [1,000 m] or reduce  maximum ambient temperature by 1° per 656 ft [200 m].

Danfoss makes the life easier. If you are looking for the best motors then Danfoss is the place to go! This adjustable frequency drive is professionally designed to operate standard three-phased asynchronous motors.