Product Description
The TDA 1.1-100-3-AP0 main spindle controller offered by Bosch Rexroth should be mounted inside its control cabinet using an Allen screwdriver that has a shaft length of over 400mm. The programming module must be fitted in place over the product using a knurled screw. The device should encompass the earth connection of the motor. If multiple controllers are used and they cannot be installed near each other, their DC link circuit bus conductors must be as short as possible. The unit has a continuous effective current of 70A. It has a weight of 10.5kg. The drive performs a braking action and comes to a standstill while cutting OFF the power supply whenever a fault is encountered.
The power connection to this spindle controller should always be disconnected before inserting or removing its programming module. The product comes equipped with an additional encoder input for the second motor feedback signal or spindle feedback. The device supports a maximum installation elevation of 1,000m above sea level with nominal data. It can be used in hot and temperate, cold and dry climate zones. The feedback, NC and power connections of the unit encompass the same terminal or plug-in connector assignments.
The controller has an IP 10 degree of protection in compliance with DIN 40 050 specifications. The product is equipped with a +/-10V analog command value. The unit does not have any additional interface. It must be properly connected as well as commissioned before the startup. The functions of the drive can be activated or modified using the application parameters stored in the programming module. The device should not have a load and neither be tipped nor dropped when it is being transported. This main spindle drive controller can be delivered to any address globally with a one year warranty period from Wake Industrial.
Wake Industrial Warranty
