Product Description
The SM 6.5/30-GC16 is a trustworthy servo module by Rexroth Bosch Indramat, boasting an interface for controller area network (CAN). With its lightweight construction, this servo module can be used to efficiently control servomotors during operation. It can operate in a much higher temperature range, which allows it to control the servomotor’s performance even in extreme conditions. The SM 6.5/30-GC16 has a continuous current of 6.5 amperes during operation, assuming fanless construction. If the SM 6.5/30-GC16 comes with a fan, the continuous current can safely reach up to 15 amps. Whether the module has a fan, the SM 6.5/30-GC16 can only tolerate a peak current of 30 amperes for approximately 5 seconds.
Based on its official documentation, the SM 6.5/30-GC16 has a DC link voltage of 325 volts. For servo modules like the SM 6.5/30-GC16, the DC link voltage is the potential difference at the connection point of the servomotor and servo module. During nominal operating conditions, the SM 6.5/30-GC16’s internal clock runs at a frequency of 5 kHz. The associated power loss of the module during operation is 13 watts. For installation levels below 1000 m above sea level, the module does not experience any form of derating. At most, this servo module can prevent accidental finger touch from the user.
For Bosch Rexroth-based automation systems, all VM and SM modules are usually mounted in a module rack with bus board. Specifically, the SM 6.5/30-GC16 requires only one slot in the module rack. To maintain the pristine condition of the servo module, it is recommended to keep the ambient temperature during operation between 0 and 55 degrees Celsius. To get this high-quality servo module with a 1-year warranty, message Wake Industrial’s sales team immediately.