SF-A5.0700.030-14.039

Product Description

The BOSCH brushless servomotor has variants and SF-A5.0700.030-14.039 enables users to access the basic version of the brushless servo motor with holding brakes, and without mating connectors. The maximum speed that can be achieved in this variant is 3,000 revolutions per minute. It has the basic type of construction IM B5 in accordance with DIN IEC 34-7 that can used as IM V1 and IM V3. IM V3 is a flange pointing upward and IM V1 is a flange pointing downward. With IM V3 remaining liquid in the flange end shield is not admissible but in IM V1 is admissible. It is only admissible for an oil-tight flange on the output side in case of lubrication and heat dissipation at the sealed point are ensured by means of a suitable oil level or spray oil lubrication.

The ball bearing is located on the outside flange side, and it has a long-lasting life of 20k hours. This allows the motor to run flawlessly for even years. It is protected by IP67 standards and the transferable holding brake of the SF-A5.0700.030-14.039 is 56 Nm at 120 C. The supply voltage of the holding brake is 24V with a rated current of 1.33 A. The moment of inertia of the holding brake and the mass of this series of motors is 30 x 10-4kgm2, and 3.8 kg respectively.

The encoder type of the SF-A5.0700.030-14.039 is Single-turn (STG), option Multi-turn (MTG) with a precision of 20 angular secs and resolution of 8m incr./rev. The LRA is 45 amperes and the LRT is 69 Nm at 200 rpm and winding over temperature at 100K. The maximum length without holding brake is 483mm and the shaft has a dimension of 32 diameter mm x 58 mm.