MSK071D-0450-FN-S3-UG0-NNNN

Product Description

The MSK071D-0450-FN-S3-UG0-NNNN synchronous servomotor by Bosch Rexroth works in unison with a drive controller of the same manufacturer to render a cost-effective drive system. The motor can be used in explosive environments. This product is characterized by a standard design. The device operation must be done using only the specified software and firmware. The unit renders the application-specific functions properly only if the drive controller has already been programmed. Its connectors should not be touched during operation. The motor exhibits reduced performance when it is used outside the ambient conditions. The product requires a cooling time of approximately five times its thermal constant.

This device deploys a liquid cooling mechanism. The unit encompasses a grounding connection. It is essential to clean any spilled liquid from the motor during handling and mounting to eliminate the risk of falling. The motor must incorporate mechanical fastening of its cable ends with cable clamps. The product tends to trigger ignition sparks when its connectors are connected or disconnected. The device poses a safety risk due to maximum impact loads and vibration. The unit must undergo an acceptance test every time it has been changed. It should not be used when there are chances of frequent malfunctioning. This motor comes with a one-year warranty for shipping across the globe.

The product might experience deterioration of its gaskets because of unavoidable temperature fluctuations. The device is mounted to a flange as per DIN 42948 specifications. This unit encompasses a DS M10 centering hole for its smooth output shaft. Its encoder depicts a supply voltage of 7V to 12V. The motor uses its inbuilt encoder system to position it and control its speed. This product has a 240° rotatable electrical connector. The device has low heat dissipation through its flange with transmission fittings. The unit has an additional connection on its flange for equipotential bonding.