MSK070C-0150-NN-M1-UP0-NNNN

Product Description

The MSK070C-0150-NN-M1-UP0-NNNN synchronous servomotor from Bosch Rexroth is used with the manufacturer’s drive controller. The drive controller helps to control and monitor the operation of the motor. The motor should be operated only as intended to avoid personnel injury or damage to property. The product is not intended to be used underwater. The device belongs to the MSK product group of such offerings. The unit is intended to be operated by qualified and trained personnel. The associated drive must be only if the application adheres to the national EMC regulations. The motor must be permanently connected with the ground wire before using it.

The servomotor tends to have a hot surface during operation. This product comes with a type plate highlighting its type designation and technical details. The device is intended to be used only with spare parts and accessories approved by the manufacturer. The unit may exhibit ignition sparks if its connectors are connected and disconnected under load. Its grounded conductor must be fixed before commissioning. The motor has a size code of 070. The product must be subject to an acceptance test before the initial startup of the system. The MSK070C-0150-NN-M1-UP0-NNNN motor is backed up by a one-year warranty.

The motor may have a high temperature if it is overloaded. The product comprises a keyway shaft and does not have any holding brake. The device can operate at a maximum temperature of 55°C with the derated data. The unit works with an encoder with a Hiperface interface. This encoder helps in preserving the absolute position of the axis even after the motor has been turned OFF. The cooling process takes place by means of natural convection. This motor depicts a high torque density. The product supports the fitting of a blower if needed. The product has a size of 140 x 238 x 58mm. The servomotor can be shipped to any part of the world based on your preference.