MSK050C-0450-NN-M2-UP1-RNNN

Product Description

The MSK050C-0450-NN-M2-UP1-RNNN synchronous servomotor offered by Bosch Rexroth comes with an IP 65 degree of protection according to EN 60034-5 specifications. The product can be installed both horizontally and vertically. The device must not have any fluid accumulation at the output shaft for a long time as it can penetrate into the motor and cause damage. This unit comes with a RAL 9005 black colored paint for its housing. Its keyway shaft permits form-locking torque transmission with constant direction as well as low shaft-hub connection requirements. This shaft might get damaged due to intense reversing operation and may break because of increasing deformation.

The output shaft and radial seal of the product should not have direct contact with the machining medium. The device bearings and shaft are subject to axial and radial forces during operation. Its bearings have a nominal lifespan of 30,000 operating hours. These bearings must be replaced when running noises occur and their nominal service life has been reached. The connection cables fitted on this unit have to be checked at regular intervals and replaced if needed. The motor should be cooled down before any service or repair is done. The MSK050C-0450-NN-M2-UP1-RNNN motor is delivered in custom military-grade packaging to avoid damage during transit.

The live parts of this device should always be touched only if their voltage is below 50V. The unit is not meant to be worked on if it has a very hot surface. This motor has to be dismounted from the motor and stored properly when it is disassembled. The product is intended to be deployed only in its original state without any hardware modification. The relative air humidity and absolute air humidity of the device range between 5% and 95% and 1g/m³ and 29g/m³ respectively. The servomotor is associated with a warranty tag for one year.