Product Description
The MS2N04-B0BNN-ASDL0-NNNNN-NN synchronous servomotor manufactured by Bosch Rexroth must not be operated for residential use. This motor should not be directly connected to a three-phase supply network. The product encompasses its output shaft on Side A. This device must have no fluid accumulation around the output shaft when the output shaft faces upwards. The unit operates with nominal data at a temperature of up to 40 degrees C. It has reduced heat dissipation when its surface is soiled.This motor must be free of salt mist and condensation on its surface all the time. The product may cause material damage or personnel injury because of improper handling. This device should not be lifted by using the output shaft. The unit is intended to be connected in the dry and de-energized state. It has no special design and a standard flange exactness. This motor must be operated and maintained only by qualified personnel. The product should be disconnected from the power supply if it is going to be kept unused for a prolonged period. This device must be free of load during its transportation and storage phases. The unit has to be run at 800 rpm to 1000 rpm speed without load after a storage period of more than 12 months. It supports a maximum axial shock load of 100 m/s^2 for 11 ms.This motor must be installed and operated only after reading its documentation. The product should be properly connected with its protective conductor before startup. This device should not be subject to strikes or impacts on the shaft end. The unit has two temperature monitoring systems that work independently of each other. Its output shaft depicts a diameter of 14 mm. This synchronous servomotor portrays an output temperature based on the encoder variant.