MMD082A-030-EG1-CN

Product Description

The MMD082A-030-EG1-CN servomotor is manufactured by Bosch Rexroth. The power supply input terminal of the AC motor must not be connected inversely with its output terminal. The output terminal of the device should also not be grounded. The ground terminals of the motor and driver must be connected completely. One-point grounding must be done with the grounding terminal present in the noise filter using Class 3 or higher grounding. The motor connection terminal must be connected to each phase coil present in the servomotor. This motor can be dispatched to any address of your choice.

The MMD082A-030-EG1-CN has a winding code of 030. The feedback for the motor is received through an incremental encoder with 2,500 increments. After troubleshooting the cause of the alarm in the motor, the motor must be restarted. If the motor is restarted without solving the cause for the alarm, the motor may malfunction. The product features a voltage rating of 200V. The shield in the relay cable on the motor side and the covering of the shield wire appearing from the encoder must be connected. The E-terminal of the motor must be connected to the ground terminal of the terminal block and grounded.

The power supply to the motor gets shut off and the dynamic brake is activated when the COM-connection is opened. The motor speed with polarity is displayed on an LED display. The brake of the product is controlled by the output signal of the driver. The unit encompasses a plain shaft with a sealing ring. The device has a nominal motor speed of 3,000min^-1 and a maximum theoretical speed of 4,500min^-1. The brake of the motor has a voltage rating of 24V and a current rating of 0.4A. The MMD082A-030-EG1-CN comes with a one-year warranty period.