MMD022A-030-EG1-KN

Product Description

The MMD022A-030-EG1-KN servomotor works along with the DM01.1-W0 22 servo drive controller from Bosch Rexroth. The electrical connection for the servomotor is established using a plug connector that encompasses a 25cm cable to the A-site. The product has a length code of A, a winding code of 030 and a motor size of 22. The device must be free of any load when its trial run is executed. If all figures of the LED display flash during operation, it indicates that the AC unit is in TRIP status. The servomotor-driver combination makes use of a 270F capacitor that has a stored energy of 8.91J.

The load inertia must not be more than or equal to 30 times the inertia of the servomotor. The housing, output shaft and brake, feedback and power cables of the servomotor feature an IP 65 protection category. The feedback and power connections must be mounted properly by trained personnel to avoid damage to the motor. The device has a nominal motor speed of 3,000min^-1. The unit has a size of 128mm with an incremental encoder and a holding brake. The motor comes with a warranty period of one year and can be delivered to any address across the world through our reputed delivery network.

When the motor transitions from a power-on state to a non-power state by activating the protection function, the BRK-OFF signal will have a value of OFF. The device features a continuous torque of 0.64Nm when it is in standstill mode. It has a weight of 1.4kg and a rotor motor inertia of 0.2 x 10^-4 kgm² with the brake fitting. The maximum length of wire that is used for input/output connection should be 3m. The servo driver used with the servomotor has an output power rating of 200W and a 3-phase continuous input current rating of 1.1A. The driver has an accuracy of 5mv +/-2%.