MHD115C-024-NG1-BA

Product Description

The MHD115C-024-NG1-BA synchronous motor from Bosch Rexroth is used along with the manufacturer’s digital drive controller. This motor is widely used in machine tools. The product is characterized by high operational reliability. This device belongs to the MHD product group of such offerings. The unit encompasses permanent magnets made of special magnetic materials in its rotor. It must be operated only as intended to prevent the chances of property damage and/or personnel injury. The product should be used only in the explicitly specified configuration. The device tends to have a very hot housing during operation. The unit features live electrical parts during operation.

The motor must have a permanent connection with the ground wire as per the connection diagram before it is turned ON. It may be needed to connect additional sensors and actuators to control and monitor the motor. This product may trigger dangerous drive movements due to its faulty control. The device has to be disconnected from electrical power when it is being serviced or during a long period of discontinued use. The unit poses the danger of explosion if it is cut, open or disassembled in a pressurized state. It supports a flange of size 192mm. The AC motor has a B05 design.

The product can be installed both horizontally and vertically. The device should never have fluid accumulation at the output shaft if it is installed in the vertical orientation. The unit comes with a RAL 9005 prime black coat. It can be fitted with blowers when there are extreme loads during constant start-stop operation. The motor encompasses a holding brake with 70Nm torque. The product depicts an IP 65 degree of protection. The output direction of the power connector fitted in the device is directed to the B side. This motor is available with a one-year warranty and can be shipped all over the world.