Product Description
The MDD112D-N-030-R2L-130GB0 Bosch Rexroth digital AC servomotor cannot be put to use without a digital drive controller. This motor features a size code of 112. The product installation is possible both horizontally and vertically. This device is a good choice for incorporating into grinding machinery. The unit uses materials like iron oxide or rare earth for its permanent magnets. It has two sets of windings. The motor shaft fitting is done on the rotor. This product supports operation under poor environmental conditions. The device has high dynamics and high overload capabilities. This unit has a 49.5A phase current with natural convection cooling mode.
The motor features a 537mm overall length. Its fixed bearing is positioned on the B side. This product is compatible with a mounting flange that features either throughholes or threads. The device housing has a standard design to support both natural convection as well as surface cooling. This unit comprises a cylindrical shaft as per DIN 748, Section 3 specifications. It utilizes an INS 172 type power connector. The motor incorporates either a straight connector or an angle connector for its feedback. This product achieves non-positive torque transmission with its plain shaft. This motor is available with a year’s Wake Industrial warranty.
The product has a reduced balance class as per DIN VDE 0530, Section 14 specifications. This device is subject to a load on the shaft when it is affected by radial and axial forces. The unit has to be run at approximately 100rpm speed as a part of the reseating process. Its shaft encounters thermal stress when bevel gears are used and can cause the B-side bearing to get damaged. The motor has a continuous current rating of 90.9A with surface cooling in standstill mode. This product installation elevation must ideally not exceed 1000m over sea level. This MDD112D-N-030-R2L-130GB0 motor is shipped to any address irrespective of the country you live in.
Wake Industrial Warranty
