Product Description
The MDD112C-L-020-N2L-130PB0 digital AC servomotor with a drive controller offers an automatization system that features a rapid response and cost-effectiveness. The Bosch Rexroth motor works best when a high degree of synchronization is required. This product depicts low inertia because of the materials used for its permanent magnets. The device features high cyclic load capacity and electronic commutation to support start-stop operation continuously. This unit uses its digital servo feedback for the evaluation of its position as well as speed. Its keyway shaft is attached to the rotor. The motor operation can be done under weatherproofed conditions in stationary mode as per EN 60721-3-3 specifications.
This product has to be free of liquid collection around the shaft with IM V3 mounting orientation. The device has a standard 130mm pilot diameter. This unit uses a flange to permit mounting as per Design B14 or Design B5 with either holes or throughholes in the flange. Its coating is resistant to diluted lyes and acids. The motor shaft is designed in accordance with DIN 6885-1 specifications. This product is subject to a multi-axial stress state at the shaft-hub connection point because of torsion. The keyway shaft of the device can get fractured due to increasing deformations. This MDD112C-L-020-N2L-130PB0 motor features a warranty of one year.
The motor cooling can be done by opting for surface cooling if needed. This product reseating process has to be executed when it is stored for more than two years without use. The device housing comprises a larger-than-usual power connector. This unit has a torque constant of 0.94Nm/A at 20°C. It exhibits derated or less performance when put into operation between 45°C and 55°C. The motor features provisions for inserting two lifting screws complying with DIN 580 specifications on the housing. This motor can be delivered to any address worldwide through our global network of well-known freight partners.
Wake Industrial Warranty
