Product Description
The Bosch Rexroth MDD112B-N-020-N2L-130PA2 AC servomotor should not be used without a drive controller. This motor is best suited for applications where synchronization is of prime concern. The product has permanent magnets fitted in its rotor. These magnets are made of special materials like iron oxide or rare earth. The AC motor is a good choice for deployment under environmental conditions. The product is associated with a 112 size code. This device houses a temperature sensor in its windings to monitor the motor temperature and prevent damage because of overload. The unit has a holding brake with 60Nm holding torque. It weighs 36kg.
The motor feedback helps in speed evaluation of the digital motor and detecting the position of the rotor. This product can be installed at an elevation of 0m to 1000m above sea level. The device has B-length code. The unit is equipped with a housing that renders protection against contact with high voltage. It is meant to be mounted in either shock-damped or shock-decoupled form when it is used with press feeds. The motor supports B14 design mounting. The product installation in vertical orientation can be done with the shaft to the top or bottom. This device is available with a year’s Wake Industrial warranty.
The motor encounters radial as well as axial forces when it is in use. This radial force depends on the point where force is applied and its average speed. The unit portrays 5.7mH winding inductance. The holding brake in this product works on the closed circuit principle and is activated by the related drive controller. The device is to be run at approximately 100rpm speed for reseating it before use after a prolonged storage period. The unit has its power connector directed to the A-side. It depicts standardized electrical connections. This MDD112B-N-020-N2L-130PA2 motor is sent to its destination through reputed freight carriers.
Wake Industrial Warranty
