Product Description
The manufacturer of the MAF100D-0250-FQ-S2-AH0-05-N3 servo motor is Bosch Rexroth. Operation in the ambient temperature range of 0 to 40 degrees Celsius is intended for this servo motor. DIN EN 60034-1 defines its insulation class as 155. The coolant supply temperature has to be kept between 10 and 40 degrees Celsius, and liquid cooling is needed to offset the motor's 1.94 kW of power loss. For efficient cooling, the coolant flow rate must be at least 2.8 liters per minute. Within the motor, a 0.11-liter-capacity duct carries the coolant. Coolant input pressure is limited to 6.0 bar maximum.
At an oscillating amount level of 05, which signifies its vibration level, the servo motor is dynamically balanced. Because of its IP65 degree of protection, it is shielded against water jets and is dust tight. Although the motor can run at 2500 rpm at its rated speed, around 2000 rpm it begins to lose torque. For a limited period of time, it can generate 40.24 kW of power and 177.5 Nm of torque, using a maximum 10-four A current. Up to 9000 rotations per minute are possible with this module, which has a maximum speed of 9000 rpm.
When at a standstill, it can pull 56.1 A of electricity and provide 80 Nm of torque constantly. Sixty-three percent of the motor's ultimate temperature is reached under rated load in 3.5 minutes, according to the motor's thermal time constant. A cycle of five minutes is required to establish a thermal stable state in periodic operating mode (S6) with a 44% duty cycle. Given the capacitance of its power connections against the housing, the motor has a discharge capacity of 9.2 nF. The motor's spinning magnetic field is produced by its last three pole pairs. Our warranty lasts for a year when you purchase this module.
Wake Industrial Warranty
