Product Description
The MAD180D-0200-SA-S2-FH0-35-N1 asynchronous housing motor produced by Bosch Rexroth has an IP 40 protection rating for its output shaft with vertical installation. This motor may get damaged due to the ingress of fluids. The product must be used in its original state without structural changes. This device must not be attached or connected with components that are not explicitly mentioned by the manufacturer. The unit should not be installed or operated in a damaged or defective state. It must be used after reading and understanding the relevant safety instructions.
This motor must not be operated when there is an extreme temperature fluctuation. The product should at no time be operated without the drive controller or fan. This device is cooled through air currents that are guided across its surface using air baffles. The unit deploys a blowing action for its fan. Its fan must not be used when the surrounding air has abrasive particles or a corroding effect. This motor has two temperature sensors in its windings for its protection. The product should be shut down only after switching off the protection switch for the fan. This device is meant to be disassembled only after securing it against dropping or movements. The unit may need the fan to be dismounted for troubleshooting or maintenance measures. Its fan housing has a high temperature after the motor operation.
This motor tends to restart automatically after a power failure when voltage is applied. The product needs a regular visual inspection to be carried out on its fan once in six months. This device may malfunction if there is a problem with the internal temperature sensor. The unit is likely to have an excessively high housing temperature if its original parameters have been changed. It should be operated only in the specified configuration and combination of components. This asynchronous housing motor may have a high electrical voltage because of an incorrect connection.
Wake Industrial Warranty
