Product Description
The MAD160C-0200-SA-C0-AH0-35-N1 asynchronous motor has a maximum speed of 6,000 min-1. The Bosch Rexroth motor comprises a plain overhead output shaft without any shaft sealing ring on it. This product cooling action takes place by means of surface ventilation. The device installation as well as operation must never be done in a damaged or improperly working state. This unit will perform the application-specific functions correctly only if the drive controller is programmed before startup. It cannot be operated under extreme temperature fluctuations. The motor electrical installation is to be done by only qualified and trained persons. This product may cause bodily injury when its pressurized lines are handled improperly.
The device makes the drive controller move unfavorably when it houses defective components. This unit has an incremental encoder fitting with 2,048 increments. Its electrical connector is on the A side of the housing. The motor portrays IP 65 protection class. This product supports periodic operation with S6 operating mode. The device-related key speed is the same as its rated speed without derating. This unit installation cannot be done beyond 3000m elevation over sea level. It is necessary to wear safety apparel when working on its housing surface is hot. The asynchronous motor depicts a warranty tag of one year period.
This product has less performance-oriented output when the setup elevation is between 1000m and 3000m. The device portrays a 0.5°C/min speed of temperature change at the time of operation. This unit has protection against a water jet sprayed on its housing from all directions through a nozzle. Its motor data and the utilization factor have to be multiplied if the setup height or ambient temperature is exceeded. The motor installation is not possible vertically with foot and flange mounting. This product has Class F or 155 insulation class according to DIN EN 60034-1 specifications. The asynchronous motor shipment takes place through trusted delivery agents.