Product Description

MAD130C-0200-SA-C0-BH0-05-N1 is an asynchronous housed motor produced and designed by Bosch Rexroth. This particular motor is from the MAD series, which uses a fan unit that is attached to it to push ambient air over the surface of the motor to cool it down as opposed to natural convection. The motor has the potential to be used as a main spindle motor or as a servo motor, depending on your use case. The motor is built for high endurance and performs efficiently in poor conditions as well. The motor has an IP65 international protection class that allows the motor and the fan to operate in all conditions.

The size of the motor is marked 130, while its length is specified with the letter C. The motor winding for the motor is 0200, and it uses an axial fan to blow cool air over its surface as mentioned above. The motor is supplied an incremental encoder with 2048 increments that allow effective control over the speed and position of the motor. The electrical connection to the motor is provided through a connector on its side B, and it comes with a plain shaft without shaft sealing ring.

MAD130C-0200-SA-C0-BH0-05-N1 is not supplied with a holding brake. However, it can be mounted using flange mounting only, and does not have the option for foot mounting. The bearings in the motor are marked N, which specifies that they are standard bearings used across MAD series motors. The total mass of the motor, including the blower, is measured to be 119 kilograms, and the maximum speed of the motor tops 253 Nm. The thermal time constant for the motor is 50 min, and the noise level is given as 70 decibels.