Product Description
The MAD100D-0150-SA-S2-KK0-05-N1 asynchronous housing motor delivered by Bosch Rexroth cannot be operated without a fan. This motor must be checked for proper electrical and mechanical connections after every 1000 operating hours. The product should be secured against falling before it is disassembled. This device has a nameplate with its type designation, key technical details, and approvals fitted on the housing. The unit is balanced dynamically according to EN 60034-14 specifications. Its motor protection switch must be turned off when the motor has to be deactivated. This motor comes with grease lubrication on its bearings.The product features protective sleeves on its plug-in connections and shaft and should be removed only just before assembly. This device should not be made to undergo repeated high-voltage tests as this can cause damage.
The unit is subject to axial and radial forces when it is operated. It can withstand a maximum axial load of 10 m/s2 between 10 Hz and 2000 Hz frequency range. This motor can be operated continuously within Class 3K4 limit ranges. The product supports a maximum operating temperature of 55 degrees C. This device does not depend on the drive controller for the operation of its fan. The unit has no holding brake. It uses a RGS1003 connector for the encoder connection.This motor may need two power cables to be connected if a single cable cannot be used due to the large bending radius. The product has three terminals on the terminal block used for the power connection. This device comes with the power connection on its upper side. The unit must not be directly connected to a mains power supply. It can be used with gearboxes of other manufacturers only after doing a compatibility check. This asynchronous housing motor must be operated after reading and understanding its safety instructions.
Wake Industrial Warranty
