Product Description
MAD100B-0250-SA-M2-KQ1-35-N1 is a servo motor. It is manufactured by Bosch. The motor is a MAD series product. It supports surface cooling and is equipped with an axial fan. Rated motor operation requires 0 to 40 degrees Celsius temperature. Outside this range, the motor output torque and current will fall below rated values. Derated operation is possible but not recommended, as it can lead to equipment malfunction and failure. The MAD100B-0250-SA-M2-KQ1-35-N1 motor has a speed rating of 2500 RPM. The maximum speed of MAD motors depends on the type of bearings used. With standard bearings, the MAD100B-0250-SA-M2-KQ1-35-N1 motor can sustain maximum speeds of 9000 RPM. MAD motors are servo motors. They are equipped with an encoder for feedback. Singleturn and multiturn encoders are available. A multiturn encoder is installed on the motor and provides accurate position and speed measurements.
MAD motors can get damaged if operators connect them directly to AC mains operating at 50/60 Hertz line frequency. Therefore, these motors must only be connected to a suitable motor controller. In addition to supplying motor power, the controller modifies its output based on feedback to precisely control motor parameters such as speed and position. Rated output torque of the servo motor is 25 Nm and it can deliver 61.5 Nm maximum torque. The rated output current of the motor is 16.2 Nm and it can deliver maximum 28.3 Amps. The rated power output of the motor is 6.5 kilowatts and it can deliver 13.33 kilowatts peak output. A holding brake is installed on the motor. This is a safety device that prevents accidental motor movement. The motor controller provides the electrical release signal for the brake.
Wake Industrial Warranty
