Product Description

The Bosch Rexroth MAC090C-0-KD-4-C/110-A-0/WI520LV/S001 AC servomotor supports a mounting flange with either throughholes or windings. This servomotor incorporates an incremental encoder that works with either sinusoidal signals or square-wave pulses. The product can be used in machines with low shock loads. This device has a standard type tacho that matches its nominal speed. The unit may generate a velocity feedback with residual ripple through the tacho feedback. Its encoder is extremely resistant to environmental conditions. This motor connection to the encoder must be done using shielded cables. The product encompasses protective covers that should be removed only just before mounting. This device must not be subject to impacts or heavy loads on the output shaft during the mounting or commissioning stages as this can damage the output shaft. The unit encompasses spigot nuts on its power and feedback connectors for tightening the cables. Its cables must be routed as per the specifications given in its documentation. This motor has a rating plate with its type designation and key technical details. The product related tacho feedback cable has a maximum length of 75 m. This device-associated power connector is directed to side A. The servomotor is cooled by natural convection. This unit can be put into operation with a DSC drive controller from the same manufacturer. Its tacho feedback is realized by means of a tacho generator with rotor position detection. The product uses cables with an IP 65 protection rating for its power, tacho feedback and encoder cables. This device is always integrated with the tacho feedback. The unit has no blocking brake. Its peak torque can be used over a wide speed range.