Product Description
AC (Alternate Current) servo motor MAC063D-0-FS-4-C/095-B-0/WA612XX weighs 8.8 kilograms (kgs). Bosch makes this MAC rotor. This Alternate Current motor uses 22/22 VA for axial and radial cooling. Radial and axial cooling use AC 115-230 as the nominal voltage. The frequency is rated at 50/60 Hz (hertz). Radial cooling weighs 0.7 kilograms (kgs) and axial cooling 0.8 kilograms (kgs).
The MAC AC servo motor's unique structure makes it reliable. Brushless motors and lifetime lubricated bearings make operating easy. The bearing rally design allows direct attachment of pinions and belt pulleys, allowing higher radial loads. External forces integrate on the motor shaft. MAC AC (Alternate Current) servo motors are permanent magnet-excited with electronic commutation for light and heavy duty factories. The rotor's permanent magnets are composed of materials that allow low-inertia motors. MAC063D-0-FS-4-C/095-B-0/WA612XX AC (Alternate Current) servo motor feedback is usually tachofeedback. For position evaluation, this servo motor can have an encoder installed.
The following structural properties make this MAC AC (Alternate Current) servo motor reliable: Maintenance-free operation with brushless motor and lifetime lubricated bearings. The nominal speed of this AC (Alternate Current) servo motor is 2000 m/s. Continuous stationary torque is 4.4 (6.6) Nm. Standstill continuous current is 5.0 (7.9). Its rotor inertia is measured to be 9.9 x 10-4. The bearing assembly design on this Alternate Current Servo allows direct shaft installation of pinions and belt pulleys, permitting high radial loads. External forces are clearly assimilated by the motor shaft. Radial forces are absorbed by the motor's Side A floating bearing. Side B absorbs axial forces. It is important to note that the parenthetical values stipulated above apply to versions that fully support surface cooling.
Wake Industrial Warranty
