Product Description

The KDV 1.3-100-115V Bosch Rexroth power supply has a modular profile. This power supply can be used to power more than one servo drive at a time. The product must be allowed to cool down for at least 15 minutes after it has been switched off. This unit must be operated in its original state without modifying its configuration. It must be handled by only qualified and trained personnel. This power supply is noted for its robust performance. The product cannot be mounted diagonally or horizontally. This device encompasses a heatsink on its back panel and can be detached if it is not needed. The unit must be handled using suitable lifting equipment. It has a mass of around 20 kg. This power supply has the ability to absorb the regenerated power from the servo drives when they operate in regeneration mode. The product supports a three-phase operating voltage of 380 V to 460 V. The device encompasses a Bb1 contact that opens up and switches off the power immediately when a fault is encountered. This unit supports the protection of the related line connections by using circuit breakers and slow-blow fuses. The power supply comes with a wide range of monitoring functions. It is supported by a highly efficient heat dissipation system. This product is protected against splashes of water and penetration of dust particles. The device shows a slight dip in performance when the operating conditions are above the specified ambient conditions. This unit has a DC bus voltage of 300 V. It is primarily intended to be used in the manufacturer's digital control servo systems.