Product Description

The KDS1.1-30-300-W1 servo drive by Bosch Rexroth incorporates cold-running technology. This drive portrays a flush mounting style according to DIN VDE 0160 specifications. The product is used along with a MAC 90 to MAC 160 series servomotor in a drive system. This device can function like a torque-controlled drive. The unit is fitted with a programming module. It encompasses two summing inputs. This drive limits the external torque and current by applying an analog voltage. The product continues to remain active for up to 300 ms after its power signal has been turned off. This device can be connected with other servo drives of the same or a different type. The unit causes a reduction of the motor current and torque by 2% per degree rise of temperature when the operating temperature range is 45 °C to 55 °C. Its control cabinet must be completely closed at the time of operation. This drive should be connected only according to the specified instructions. The unit must be allowed to cool down for at least 15 minutes after its power supply has been disconnected. Its feedback connection should be established using a shielded cable that is no longer than mm. This drive must be properly earthed before it is turned on. The product should not be operated near high-frequency radio equipment. This device uses a link circuit bus bar for the power connection to the adjacent equipment. The unit has high mains voltage at its L1, L2, and L3 terminals when it is in use. Its protective conductor must have a fixed connection at the appropriate points.