HDS01.1-K075-R

Product Description

The HDS01.1-K075-R drive controller is powered by a power supply connected to the drive-through an X1 bus connection.  A flat-ribbon cable joined to the power supply unit connects the X1 connector to the power supply. The maximum allowed power connections should not exceed one meter if an extension cable is used. The drive controller manufactured by Bosch Rexroth is equipped with a start lockout AS+ and AS-. The lockout system controls the relay input for relay coils with a voltage of 20V to 30V and power of 1.5W. The starting lockout system is an operational safety mechanism that secures the drive controller and the connected motor from unprecedented startups when an error occurs. The servo drive is used in machine tools, textile, printing, packaging machines, robotics, and handling machines. 

The HDS01.1-K075-R control unit is made up of different serial interfaces like the RS 485 and the RS 232 interface. The serial interface is used in programming, parameterization of the drive controller during commissioning and servicing. The RS 485 interface allows for; a transmission length of up to 500m, the connection of a serial bus with up to 31 participants connected via a two-wire cable, signal transmission rates of 9600/19200 baud, and the use of a visually supported PC unit. Through the RS 485interface, it is possible to connect several DKCs with Drive Top without exchanging the serial interface cables.

The HDS01.1-K075-R is available with two modes of communication - the SERCOS interface type DSS02.1M and the ANALOG interface type DAE02.1M. These plug-in modules are the interfaces that connect the drive communication module to the control module. This unit can be shipped globally with a one-year warranty period from Wake Industrial.