Product Description

The HDC01.1-A100N drive controller from Bosch Rexroth is one of the several drive controllers in the DURADRIVE category. This drive controller is used in conjunction with different types of motors from the manufacturer across various series. The product has a high degree of functionality. This device can be used under difficult ambient conditions. The unit is suitable for a wide range of drive tasks for various applications. It has no communications interface. This drive controller must be installed only in the vertical position. The product has a peak-to-peak amplitude of 0.3 mm at a frequency ranging from 5 Hz to 57 Hz. This device also portrays a random vibration distortion when it is in operation according to IEC 68-2-36 specifications. The unit has an IP 65 protection class. Its power connectors must be connected only in a dry and clean state. This drive controller is not supposed to be connected directly to the mains supply. The product portrays a three-phase operating mode at the mains. This device supports a mains input voltage of 3 x 200 to 480 VAC with a tolerance of +/-10% and a mains frequency of 50 Hz to 60 Hz. The unit is connected to a programming module at its X7 connector. It comes equipped with a diagnostics button and a reset button. This drive controller can be replaced only when it is in a completely de-energized state and after making sure that the mains switch is off. The product should never be operated without a permanent ground wire connection. This device has a leakage current of more than 3.5 mA. The unit is likely to show signs of dangerous movements because of faulty control of the associated motor.