Product Description

The Bosch Rexroth HCS04.2E-W0730-N-06-NNNN drive controller must portray a minimum clearance distance of 200mm above and below the control cabinet in which it is installed. The controller cannot be installed in horizontal orientation. The product has IP 00 protection rating. This device is equipped with galvanic isolation. The unit experiences derating by 1% for every 100m rise in installation elevation above the ideal setup altitude. It is ideal for regenerative as well as motive motor operation in both directions of power flow and rotation. The controller houses a CE label on its type plate. This product comes integrated with a radio interference filter for residential areas.

The device has restricted distribution as per IEC 61800-3 specifications. This unit allows high mains short circuit powers if an HLL or an HNL choke is used without affecting its operational safety. It is controlled by turning the mains voltage ON and OFF. The controller permits a maximum of 60 switching actions in an hour as per Stop Category 0 and Safety Category 1. The product supports usage with increased continuous load at lowered dynamic overload capacity. This device stimulates shut down due to excess current flow for protection against ground fault and short circuit. This controller has a year’s backup support.

The product can function between 40°C and 65°C with reduced performance. The unit connection with the cable shield has to be established in the most direct and shortest possible way. Its analog signal lines must be shielded at one end. The controller must feature short-length motor cables when functioning with a high clock frequency. The device has an integrated Category C3 radio interference filter. The unit also portrays a braking resistor option for rapid deceleration. The controller uses an SF type mains fuse for its protection. Wake Industrial can dispatch this controller to the preferred address across the globe.