Product Description
The Bosch Rexroth HCS01.1E-W0018-A-03-E-S3-EC-EP-L3-NN-FW is a digital controller with an economy control section. It is part of the IndraDrive Cs product line. The controller is designed for use with servo motors. It is equipped with an integrated multi-encoder interface. This interface allows controller use with several types of motors, and therefore with several motor product lines. As per the type code, the product series is HCS, the series is 1 and the design is 1. The controller comes with a feeding type power supply unit. It can deliver maximum 18 Amps output current. The input voltage range is 200 to 500 Volts AC (three-phase). The HCS01.1E-W0018-A-03-E-S3-EC-EP-L3-NN-FW is equipped with a cooling fan, which enables forced-air cooling. The permitted ambient temperature range is 0 to 40 degrees Celsius. Above 40 degrees ambient temperature the controller output derates.
Bosch does not permit use of the HCS01.1E-W0018-A-03-E-S3-EC-EP-L3-NN-FW controller at ambient temperatures over 55 degrees Celsius. The controller draws cool air through an inlet and the bottom side of the housing. It releases heated air through at outlet at the top end of the unit. As the heated air is released inside the cabinet, operators must provide suitable spacing between devices in the same cabinet. Bosch recommends minimum 90 millimeters of spacing on the top and bottom sides of the installed drive unit. Integrated communication supported by the HCS01.1E-W0018-A-03-E-S3-EC-EP-L3-NN-FW is SERCOS/EtherCat. Optional modules installed on the unit support a safe torque off safety module and a module with an engineering port. The HCS01.1E-W0018-A-03-E-S3-EC-EP-L3-NN-FW ships with a standard control panel. The unit weighs 2.1 kilograms. Its housing is IP20 rated. Only qualified personnel should install and operate the HCS01.1E-W0018-A-03-E-S3-EC-EP-L3-NN-FW controller.
Wake Industrial Warranty
