Product Description
The HCS01.1E-W0018-A-03-A-CC-EC-ET-SB-NN-FW drive controller by Bosch Rexroth has a very hot surface during and immediately after operation. This controller uses a copper wire with at least 8 AWG cross-section for its equipment grounding connection. The product must be connected only with the manufacturer's cables. This device should be in the de-energized state before any work is done on it. The unit must not be operated without its DC bus connector or touch guard. Its metal back panel must be connected to the mounting surface of the control cabinet in a conductive form.
This controller must be connected to the mains choke using short and twisted cable lines. The product supports encoder systems with 5 V and 12 V voltage ratings. This device has one combined digital input/output. The unit features an analog input with a 14-bit resolution. Its control panel has a slot for inserting a microSD memory card. This controller may cause property damage or personnel injury if it is not used as intended. The product should be used only in the specified configuration and combination of components. This device must not be utilized for applications that have not been authorized by the manufacturer. The unit is meant to be operated only if the applications meet the required national EMC regulations. It tends to have a high electrical voltage because of an incorrect connection.
This controller has live connection points when the power is turned on. The product may show dangerous movements if the associated motor has software, firmware, or operator errors. This device tends to get destroyed due to prolonged storage. The unit is meant to be disconnected from the power supply during maintenance, repair, or cleaning work. Its connectors must not be plugged in or removed when it is powered. This drive controller should not be touched when its surface is hot.
Wake Industrial Warranty
