Product Description
The Bosch HCS01.1E-W0008-A-03-B-ET-EC-EP-S5-NN-FW is an industrial drive controller. It is used in industrial applications for control of motor speed, torque and position. The controller is equipped with a multi-encoder interface that is compatible with several motor encoders (Hiperface, EnDat 2.1, MSM encoder, resolver etc.). This feature allows use of HCS series encoders with a wide range of Bosch industrial servo motors. The HCS01.1E-W0008-A-03-B-ET-EC-EP-S5-NN-FW is designed for forced air cooling. However, large cabinets are required since it releases warm air inside the cabinet. HCS series devices require 0 to 40 degrees Celsius ambient temperature for nominal output. The output derates at higher ambient temperatures. Use of the HCS01.1E-W0008-A-03-B-ET-EC-EP-S5-NN-FW at temperatures that exceed 55 degrees Celsius is not permitted. Peak current output of the controller is 8 Amps. Its power section accepts 200 to 500 Volts AC input.
The controller housing belongs to IP20 protection class: it only provides protection against solids with 12 millimeter dimensions. Lack of moisture ingress protection means a suitable cabinet must used for controller installation. An integrated Multi-Ethernet interface is available on the controller. In addition, a module with an engineering port and a safety module with safe motion support are also installed. Safe motion is a safety function for monitoring and control of motor parameters such as velocity, acceleration, position. The HCS01.1E-W0008-A-03-B-ET-EC-EP-S5-NN-FW is shipped with a standard control panel. The control panel must be connected to the controller before it is switched on. This is because the control panel does not support hot-plug. The firmware for HCS series controllers must be ordered separately from the hardware. Bosch recommends allowing only trained personnel to plan and execute HCS controller installation and maintenance.
Wake Industrial Warranty
