FVCA01.2-18K5-3P4-MDA-LP-NNNN-02VRS

Product Description

The FVCA01.2-18K5-3P4-MDA-LP-NNNN-02VRS frequency converter made by Bosch Rexroth comes with a frequency command of 0.00Hz that can be changed. This value must be changed using the operator panel to start the connected motor. The converter uses an LCD equipped with a potentiometer for its operator panel. The product features a power supply voltage of 3 x 380 to 480VAC with -15%/10% tolerance. The device is designed for hanging on the wall. It has a pollution degree of 2 as per EN 50178 specifications. The unit supports a relative humidity of less than 90%. The control commands of the converter are set using the digital and analog inputs, operating panel, and serial port.

The frequency converter features several types of protection such as input and output phases failure protection, over-current protection, and grounding protection to mention just a few. The relative humidity of this product should not be less than 90% without condensation during operation. The control and signal lines of the device are to be routed at a minimum distance of 100mm from the power cables. The unit houses a Class C3 EMC filter for use in industrial environments. The LCD backlight of its operator panel gets turned OFF automatically after 80 seconds if there is no key-press during this period.

The converter should be transported between -25°C and 70°C. The storage temperature for this product ranges from -25°C to 55°C. It complies with low-voltage and EMC directives. The device encompasses a 6kHz pulse width modulation frequency. The unit features two relay outputs with 250VAC/3A and 30VDC/3A ratings. It must never be used outside the specified installation conditions. The device has a continuous rated current of 39A. This unit encompasses an external brake chopper and an external brake resistor. We can send the frequency converter with warranty support for a year to any address of your choice.