EFC5610-15K0-3P4-MDA-7P-FCPNN-L1NN

Product Description

The EFC5610-15K0-3P4-MDA-7P-FCPNN-L1NN frequency converter produced by Bosch Rexroth incorporates flexible expandability using application-specific firmware. The starting torque of the product corresponds to 200% of its rated torque at 0.5Hz frequency. The Run, Speed Control and Stop parameters of the device are to be set before use to be able to control the motor. This unit features up and down keys on its keypad for increasing or decreasing the set values. Its E0.27 parameter can be used to set the time required in seconds to rest the motor. This product can incorporate a remote potentiometer for adjusting the motor speed if the dial present on the keypad cannot be used.

The device utilizes the C1.05 to C1.09 parameters to set the parameters of the motor. The unit is intended to be stored between -20°C and 60°C. It also features relative humidity ranging from 5% to 95%. The product comprises an open collector output that supports pull-up and pull-down wiring as well as 32kHz pulse output. The converter additionally has an I/O module with a relay card featuring 4 relay outputs. This device implements a standard RS485 communication interface that utilizes shielded twisted pair cables. The unit experiences a derating of 1% for every 100m rise in altitude between 1,000m and 4,000m.

The frequency converter portrays an input current rating of 37.8A/29.9A at 380V/480V. The product disassembly must be done by rotating it to the desired angle and lifting it upwards. The copper wires in the cables used to connect the device must adhere to IEC 60364-5-52 specifications. The unit uses power and protective earth cables with AWG 6 cross-section. It allows the incorporation of gR and gL type fuses for the protection of its semiconductors and lines respectively. The U, V and W terminals of this product represent its output terminals. The converter is associated with warranty backing for one year and shipped through a well-known logistics network.