Product Description
The DKR02.1-W300Z-BE04-01-FW drive controller produced by Bosch Rexroth is fitted with a bleeder. The controller must never be used when the maximum temperature is very high or there is extreme temperature fluctuation. This product should always be installed, used, or serviced only after reading the associated documentation. The device may depict high electrical voltage due to wrong connections. Its surface tends to become very hot during operation. The unit should be operated only by trained and qualified personnel. The controller is designed for installation in commercial machinery. The product must not be used in refinery plants and elevators or to control protection equipment.
The drive controller must be started only if the machine housing the device adheres to the safety specifications as well as national safety regulations relating to the application. The operation of the product must take place only if the application meets the relevant national EMC regulations. The power connection of the device must be turned ON only after the ground wire is permanently connected. Its covers and guards must be installed properly before turning the controller ON. The protective connection must encompass a copper conductor with a minimum of 10mm2 cross-section over the entire course.
The controller may move dangerously due to faulty control as a result of wrong or unclean wiring of cable connections, software errors, or defective components. The vertical axes of the drive have to be secured against falling when the motor power is turned OFF. The installation is to be done taking the safety regulations and general instructions into consideration. The lifting of the product should be using appropriate lifting or moving equipment or tools. The device comes with a SERCOS interface. The drive should never be cut, open, or disassembled in a pressurized state. We can send this DKR02.1-W300Z-BE04-01-FW controller worldwide with warranty support for one year.
Wake Industrial Warranty
