Product Description
The DDS03.1-W030-DS09-01 drive controller offered by Bosch Rexroth has high electric voltage if it has incorrect connections. This product must not be used for radio or high-frequency equipment. The device has a rated current of 30A. The DIAX02 unit must encompass a permanent connection to the supply system. Its power connection isolation should be carried out using an emergency stop circuit. The controller comes configured to perform the desired function. The product is cooled by means of airflow inside the control cabinet. The device may require air conditioning and a large control cabinet for its installation. The unit uses analog diagnostic outputs to generate drive internal variables for test purposes.
The controller has a switching capacity of 24VDC and 1A. The product should never utilize varistors to function as protective circuits. The device cannot use the starting lockout to bring the moving axes to standstill mode. This unit has a RS 232 interface at the X2 connecting point to connect to a PC or a VT-100 terminal. It features a maximum permissible relative air humidity of 95%. This product and the servo feedback have to be connected using the manufacturer’s feedback cable whenever possible. The device supports the entry of cool air through the bottom inlet and the exit of hot air through the outlet at the top.
This product uses cables of a maximum 75m length if the manufacturer’s cables are used for power and feedback connection. The device needs an external 24VDC connection only if a motor holding brake is used. It is connected to an adjacent controller using DC bus rails. The controller must not have a direct connection between its Bb contact and a contactor coil. Its analog diagnostic outputs have an output voltage of 10VDC and a current load capacity of 4mA. This DDS03.1-W030-DS09-01 controller has backup support for one year and is shipped through reputed freight carriers.
Wake Industrial Warranty
