Product Description
The DDS02.2-W100-BE48-01-FW drive controller has a ready-to-operate Bb contact that closes when monitoring functions signal a ready state. This Bosch Rexroth controller can be connected to another adjacent controller using the E-DD3 electrical accessories kit. The product is suitable for use in robotics and handling systems. The device has to be installed only in commercial machinery. The unit is to be used only with spare parts and accessories approved by the manufacturer. It is designed to function between 0°C and 45°C with rated data. The product must be operated only if the application adheres to the related national EMC 89/336/EWG directives.
This device should be disconnected from the mains and secured against reconnection before repairing or working on it. The power connection of the unit must feature isolation through an emergency stop circuit for protection against unintentional startups. Its live parts should be covered properly before it is turned ON so that there is no possibility of contact with them. The drive controller handling as well as installation must be done considering the general safety and construction regulations. The product has an H1 LED status display on its front panel to highlight its errors and error messages.
The controller uses the manufacturer’s feedback and power cables with a maximum length of 75m. This device is connected with the motor feedback at the X4 connector. The unit implements a starting lockout mechanism to avoid the unintentional startup of the related motor when there is a fault. This starting lockout cannot bring the moving axes to standstill mode. The product has two control inputs for the relay coils. Its Bb contact cannot be directly connected to a contactor coil as this can cause the contact to be overloaded. This DDS02.2-W100-BE48-01-FW controller has a warranty period of one year and is shipped through reputed freight carriers.
Wake Industrial Warranty
