Product Description
The Bosch Rexroth DDS02.2-W100-BE46-01-FW drive controller is meant to be earthed before it is switched ON. This controller features maximum permissible absolute humidity of 25g/m3. The product has to be worked on only after at least five minutes of powering it down so that the capacitors get discharged fully. The device may move dangerously due to faulty wiring or cabling, a software error or physical component problems. The unit is intended to be stated up only after ensuring that its emergency stop switch is in working condition. It should be in standstill mode before entering the danger zone. This controller must be installed using suitable installation equipment and tools.
This product should not be subject to pinching or crushing when it is being handled. The device has a 2 version code. The unit may require a large cabinet for its installation. Its firmware gets updated regularly for accurate functioning without affecting the functions. The drive controller uses a SERCOS interface for command communication. The product comes with a continuous current rating of 60A. The device must be put into operation only within the specified ambient conditions as far as possible. Its configuration rating plate has the term COVER mentioned on it when the corresponding slot has no plug-in module.
The drive controller features an energy loss that is based on the continuous current of the associated motor in standstill mode. The unit is not designed to be installed horizontally. It should encompass a clearance distance of at least 80mm at the top and bottom inside the control cabinet for the entry and exit of cool air and hot air respectively. The product is not to be utilized when there is extreme variation in temperature. The device transportation must be done using shock-absorbing transports if needed. This controller is available with a year’s Wake International warranty for global shipping.
Wake Industrial Warranty
