Product Description
The Bosch DDS02.1-W150-DS32-00 is a drive controller. It is designed by Bosch for controlling motors from the LAR / LAF inductance motor product lines and MKD / MDD synchronous motor product lines. The DDS02.1-W150-DS32-00 supports digital servo feedback. This feature allows the drive controller to receive feedback from compatible servo motor. The feedback is used by the controller to ensure that motor parameters are as close as possible to parameter values that are programmed by the operator. The rated output of the DDS02.1-W150-DS32-00 is 150 Amps. Rated output is valid for recommended ambient and operating conditions. Rated output is not valid for non-specified ambient conditions. Controller operation under non-specified ambient conditions can also lead to malfunction or even failure. The command module that is installed on the DDS02.1-W150-DS32-00 supports SERCOS.
SERCOS is a communication standard that enables real-time serial communication across a network for SERCOS-enabled devices. The devices on the SERCS network communicate over fiber optic cables that are deployed in ring topology. The benefit of ring topology is that network communication is not affected by a single cut to a fiber or the failure of a single node on the network. The firmware for the DDS02.1-W150-DS32-00 determines the controller functionality. The controller firmware is located on the software module. This module can be removed and shifted to another drive if required. The DDS02.1-W150-DS32-00 is a convection cooled device. The controller dissipates heat inside the cabinet where it is mounted. This means that large cabinets or air conditioning may be needed for maintenance of ambient temperature within recommended values. The DDS02.1-W150-DS32-00 should only be handled and installed by qualified personnel. Only approved accessories should be used with the device.
Wake Industrial Warranty
