Product Description
The DDS02.1-F050-D drive controller houses a configuration rating plate with information that can help to get the replacement parts efficiently and quickly when there is a breakdown or a service is needed. The Bosch Rexroth product has a peak current of 50A. The device does not have a communications module. The unit can function at a maximum temperature of 55°C with derated data. It is protected against penetration of a solid object with a diameter of more than 50mm. The drive must be placed near the power supply to ensure that the minimum clearance distance between them is maintained.
The A1, A2 and A3 terminals of this controller are tightened using M6 screws with 5Nm tightening torque. The signal lines of this product must be routed away from the supply lines to avoid interference. The device comes with an S1 fault reset key as well as an H1 status display on the front panel of its basic unit. The status display is a two-digit LED display that highlights the error and warning message codes. The controller must be used only with those parts and accessories that are approved by the manufacturer. The unit should make use of motor power cables for the lines between the AC motors and the controller.
The controller supports connection to adjacent drives using DC bus rails that are included in the appropriate accessories kit. Its X1 connector is used to supply the control electronics of the drive controller. The product has two analog diagnostic outputs that are used for test purposes such as when commissioning is done. These outputs have an output voltage of 10VDC and a current load capacity of 4mA. The starting lockout of this device does not bring its moving axes to a standstill position. This DDS02.1-F050-D controller is sent to any country with warranty support for one year.
Wake Industrial Warranty
