Product Description
The DDC01.1-K150A-DG02-00 servo drive produced by Bosch Rexroth features standard noise emission at the motor end. The drive is integrated with an H1 status display for highlighting error and warning signals. Its interbus S interface module helps in establishing a connection between the servo drive and the interbus S data highway. The product must be used only in the configuration specified by the manufacturer. The drive controller incorporates an IP 65 protection inside a compact housing. The cable lead through must be installed by opening the cover shroud and releasing the knurled screw. The mains connection and the motor power connection of the drive are located at its bottom.
The X4 connector of the servo drive is used to establish its motor feedback connection. The signal lines of the drive should be grounded separately with shields. The grounding connection of the product must be done as per the manufacturer’s guidelines. The control and signal leads of the device should be routed at a 10cm minimum distance from the power cables and must cross them at a 90° angle. The unit is matched to the mechanical as well as electrical connections of the machine using parameters. The DEA 4.1 input/output interface has five outputs as well as eight inputs. The DDC01.1-K150A-DG02-00 is available with a warranty for one year.
The servo drive must encompass all the modules specified in its configuration rating-plate. The AC servomotor connected to the product has a system accuracy of +/-0.5 angular minutes. The slot for inserting the software module is housed at the top of the front panel of the device. The unit is integrated with a single-axis positioning module. Its signal lines must be shielded on one side for analog signals and on both sides for digital signals. We can send the servo drive to any address worldwide.
Wake Industrial Warranty
