DDC01.1-K100A-DA02-00

Product Description

During the installation of the DDC01.1-K100A-DA02-00, the units should be mounted with sufficient air space to allow for efficient cooling. The bleeder resistor in the drive controller gets hot during operation. Any parts of the machine or flammable materials that can be affected by too much heat should be installed, maintaining a distance of 300 mm to the air outlet. Bosch Rexroth drive controller is paired with a feedback motor to the machine. When matching the Feed Motor to the system, there must be enough radial and axial compensation with all other machine parts. The re-circulating ball screw should be paired using a toothed belt reduction gear with a mounted overhung lock washer. The front bearings on the connected servo motor help in making the pairing operation easy and fast. A reduction gear also provides rigidity and dynamic stability to the feed axis.

The DDC01.1-K100A-DA02-00 is integrated with the DLC module to meet comprehensive and demanding operations. Intensive applications of machines in transfer facilities and sequential finishing. Avoid interference in the signal and power connections by observing the following guidelines; connect all analog signals on one side. Install shields on both ends of the digital signal connections. Route Signal and control leads 10 cm away from power cables. Control leads should only cross power cables at an angle of 90.  Operate inductive loads with suitable overvoltage limiters.

IP 65 connectors are used in connecting the controllers’ power connection, motor power line, and the interface to the machine control. Other cable connections like the motor feedback cable and optional plug-in modules are inserted into the DDC drive controller through the cable lead-through on the lower part of the drive. This unit can be shipped globally with a one-year warranty period from Wake Industrial.