Product Description

X20IF1053-1 is a DeviceNet module. DeviceNet is an industrial network protocol used primarily in automation and control systems to facilitate communication between industrial devices, such as sensors, actuators, and controllers. The protocol is based on the Controller Area Network (CAN) protocol, which was originally developed for the automotive industry. The X20IF1053-1 module is part of the X20 series from B & R Automation. The module enables communication between B & R systems and systems from other manufacturers. The module functions as a DeviceNet slave and supports error monitoring. Power consumption of the module is less than 1.1 Watts. Terminating resistor diagnostics are available via LED indicator. Data transfer diagnostics are available via LED indicator. Module diagnostics are available via LED indicator and software. Network status diagnostics are available via LED indicator and software.

Physical interface on the X20IF1053-1 module is a 5-pin male multipoint connector. Maximum distance for the DeviceNet segment is 500 meters. The maximum data transfer rate over DeviceNet is 500 kbps. A built-in terminating resistor is available. The controller type is netX100. The PLC is isolated form the DeviceNet network. The X20IF1053-1 module mounts horizontally and vertically. Degree of protection offered by the module enclosure, as per EN 60529, is IP20. This means that the module is not dustproof and is also not protected from rain. Therefore, for outdoor use, it must be installed inside an industrial cabinet or enclosure. The recommend ambient temperature for vertical mounting orientation is -25 to 50 degrees Celsius. The recommend ambient temperature for horizontal mounting orientation is -25 to 60 degrees Celsius. The manufacturer recommends 5 to 95% non-condensing relative humidity for all situations.