Product Description

The 80MPF1.250S114-01 is a 2-phase hybrid stepper motor made with an uncompromising quality and precision that is required for industrial purposes. Its flange size is 60 mm and the length of the motor is 97.1 mm, hence calculating how big the motor can be is also very important, as the motor should be small and effective in tight places once again this can be achieved. Motors come with an ABR incremental sensor which adds on the position indication aspect thus reducing the positioning errors. The current supplied is 2.5 A in series 1.28 ohm resistance and 3.4 mH inductive with one phase connected to supply thus enabling smooth running.

The measured stall torque for the motor is 0.8 Nm which develops a holding torque of 1.1 Nm allowing working applications which require safe holding and stopping conditions. The detent torque on the motor is approximately 35 mNm which helps in resisting motion when the motor is in the unpowered state, mass of the rotor which is about 280 gcm2 also allows for smooth motion and good motion control responsiveness.

Positioning is accurate in finiter locations as the 80MPF1.250S114-01 has a 1.8 degrees stepping angle. The maximum surface temperature of the motor is 95 degree thus the motor is expected to last long and can be used under continuous service without overheating. Enclosure is IP65 rated which means it is protected against dust and low pressure water jets hence the motor can be used in rough industrial conditions. In general, the 80MPF1.250S114-01 is a heavy duty stepper motor precise and very dependable for environments where a high degree of accuracy is required.